Deleted:With the X.M.P of my memories activated the Biostar screen takes about 40 seconds to appear

Question

[sabrinalfmoura]

Recently I builded my new PC with these configurations:

• Biostar a520mh ver. 6.1
• Power Supply Sharkoon SHP 500W 80 Plus Bronze
• 2x8GB Crucial Ballistix 3200 MHz DDR4
• Ryzen 5 4650GE
• SSD Asgard 500GB

By default my memories was in 2666MHz and all worked fine, to appear the Biostar's screen takes about 7 seconds.

But when I enable all memories's frequency the Biostar's screen takes about 40 seconds to appear. Both motherboard and processor are compatible with memories until 3200MHz.

With this configuration all works normally but to wait more than 40 seconds to starts my PC is too much to me.

I set the frequency manually and even so the problem hold on.

I need help setting full potential of my memories in 3200Mhz without wasting time to boot my system.